6/28/2023 0 Comments Uag vmware horizonIf the load-balanced server fails to respond to the designated number of probes within the designated time period, the monitor marks it DOWN.Īs it is recommended to monitor all service ports of Horizon TCP/UDP 443 TCP/UDP 8443 and TCP/UDP 4172 we will only show you how to create a TCP 443 monitor. As long as the load-balanced server responds to the probes, the monitor marks it UP. MonitorsĪ monitor probes the load-balanced server via its service. In this blog post, I would like to show you how to configure a load balancer for UAG’s in NSX-T in front of a Horizon environment. To overcome some of the limitations you can use NSX-T Data Center logical load balancer as a load balancing solution in front of the UAG’s. Therefore, the individual IP addresses of Unified Access Gateway nodes must also be accessible to VMware Horizon clients in addition to the Virtual IP address. High availability is not used to distribute load for the protocol (display) traffic such as Blast, PCoIP, RDP. With the VMware Horizon use case, only XML API traffic to Horizon Connection Server uses high availability.UDP high availability is not supported.Only TCP high availability is supported.IPv4 is supported for floating Virtual IP address.The out-of-the-box HA solution will reduce complexity and lower your TCO but it comes with the following limitations. Unified Access Gateway appliances work with standard third-party load balancing solutions that are configured for HTTPS and also has an out-of-the-box High Availability solution. Unified Access Gateway for end-user computing products and services needs high availability for Workspace ONE and VMware Horizon on-prem deployments. NSX-T, VMware Load Balancing UAG’s with NSX-T
0 Comments
Leave a Reply. |